When buying a Tuxedo online it is important to accurately determine your sizes to get the best fit.
Please use these guidelines to choose your sizes. When in doubt please do not hesitate to contact us for assistance.
When possible we recommend that you visit a men’s formalwear store in your area and request a courtesy measurement to ensure accuracy of measurements. For your convenience we have also provide these measuring guidelines that you can follow to determine your sizes.
Please keep in mind Tuxedo fit may vary slightly from one Designer to another. Please be advised we use the guidelines everyday to correctly fit tuxedos. Occasionally alterations will be necessary to get a more tailored fit.
- All measurements should be taken in inches.
- For accuracy, please have someone else take your measurements
- Hold the tape measure straight and tight
Jacket Size & Length
Place measuring tape under arms and measure around the broadest part of the chest, just under the arm pits.
Arms should be relaxed at the side. Add 2 to this number and you will have your Jacket size.
For example a 38″ chest measurement would require a 40 Jacket.
Jacket lengths range from Short, Regular, Long, and Extra Long.
The following list shows height ranges that generally coincide with the appropriate length jacket. Keep in mind some people have longer waists, and others have longer legs. These may cause variations in the necessary jacket length. Also, be aware that some jacket lengths may vary depending on style and designer.
|Short||5’0 – 5’7|
|Regular||5’8 – 5’11|
|Long||6’0 – 6’4|
|Extra Long||6’4 +|
Measure around the neck where a shirt’s collar would be buttoned.
Measure with two fingers between the tape measure and the neck to determine the neck size for the tuxedo shirt or you can measure as we have without any fingers in between the neck and tape measure and add 1″ to the measured size. The Shirt size for the example shown would be 16 1/2″
Small fits a 14″ – 14 1/2″ Neck Size
Medium fits 15″ – 15 1/2″ Neck Size
Large fits 16″ – 16 1/2″ Neck Size
X-Large fits 17″ – 17 1/2″ Neck Size
2XL fits 18″ – 18 1/2″ Neck Size
Place the tape measure at the base of the neck centered on the spine.
Tape measure must go from the center back over the top of the shoulder, down to the point of the elbow and then down the arm to an inch and a half past the wrist bone. It is best to measure a little longer than shorter if you are between sizes.
Sleeve Lengths come in sizes 30/31, 32/33, 34/35, 36/37 and 38/39. The taller the person the longer the sleeve will likely be.
Wrap a tape measure over a shirt around your waist at the height you usually wear dress slacks. Tuxedo pants are made to be worn at the natural waist (your navel). Keep one finger between tape and body. You do not want these pants to be baggy in the waist or length.
FYI: Many of the tuxedo pants that we offer are adjustable in the waist between 3 sizes at set intervals (27″-29″, 30″-32″, 33″-35″, 36″ – 38″, etc.)
Measure your Outseam from the top of the waist band on a pair of dress slacks or pants that fit you well to the floor.
You will be looking for the length that allows for a slight break on the top of the shoe and for the pants to stop just above the heel in the back. As you can see the measurement here is 42 inches.
**We will make sure adequate Pant length will be provided, however upon receipt of your Tuxedo you will most likely need to have your pants hemmed to be the right length for you.